PVC shower tubes are commonly used parts in our family life. But do you know how PVC shower tubes are connected? As a professional PVC shower tube manufacturer, I will share with you how the PVC shower tube is connected.

PVC shower pipe connection method:

1. If the PVC pipe is connected with the water pipe, it is necessary to first clean the rubber pipe joint and soften the PVC pipe (but not burnt), then insert it on the steel pipe and cool it down. The hoop will be better.
2. The PVC pipe and the socket part are cleaned up. The smaller the gap of the socket is, the better the sanding of the joint surface is made with sand cloth or saw blade. The thin glue is evenly brushed inside the socket, and the glue is applied twice outside the socket. After 40 to 60 seconds of dryness, insert it into place. At the same time, it should be noted that the glue drying time should be appropriately increased or decreased according to climate change.
3. PVC pipe fittings are bonded with special adhesive, and the adhesive is shaken before use.
4. Do not touch the water when bonding. After the pipe is in place, it should be placed in the ditch. After the joint is dry, backfilling should be started 24 hours after the joint is dry. When backfilling, the pipe will be filled with sand to leave the joint and then backfilled in large quantities.

Four connection methods for PVC shower tubes:

1. The glass fiber method is formulated into a resin solution by using an epoxy resin and a curing agent, and after impregnating the resin solution with a glass fiber cloth, uniformly wraps around the surface of the pipe or joint leakage, and becomes a glass steel after being solidified.
2. For the treatment of leakage at the solvent bond, the solvent method can be used; at this time, the water in the tube is drained first, and a negative pressure is formed in the tube, and then the adhesive is injected on the pore of the leaking portion, Negative pressure, the adhesive will be sucked into the pores to achieve the purpose of stopping leakage.

3. For the large-area damage of the pipe, it is necessary to replace the whole pipe, and the method of replacing the pipe with the double-mouth joint can be used.
4. The ferrule bonding method is mainly for the leakage of pipes through small holes and joints. At this time, the same diameter pipe with a length of 15 to 500px is selected, and the longitudinal pipe is cut longitudinally, and the inner surface of the casing and the outer surface of the pipe to be supplemented are roughened according to the method of bonding the joint, and the sleeve is tightly attached to the water leakage after being glued.

Each of the above four connection methods has its own trial situation, and needs to be flexibly selected according to actual conditions. The above is just a few ways to connect the PVC shower tube to everyone, I hope everyone can pay attention.